metallized polypropylene capacitors CBB21 630V 223J P=10mm

  • CBB21 Polypropylene Capacitor
  • 0mm
  • Capacitace Tolerance: ±5%(J)
  • Size(T*H*W): 5*10*13mm


metallized polypropylene capacitors CBB21 630V 223J P=10mm

metallized polypropylene capacitors CBB21 630V 223J P=10mm is a non-inductive structure. It is made of metallized polypropylene film as the electrolyte and the electrode is wound. The wire is tinned copper clad steel wire, encapsulated with flame retardant epoxy resin. Good self-healing and long life. Suitable for DC and VHF level signals. DC, bypass and coupling. Widely used in filter skin, noise reduction, pulse, resonance and step-down circuits, high-frequency large current occasions, especially suitable for various types of energy-saving lamps and electronic ballasts.

metallized polypropylene capacitors CBB21 630V 223J P=10mm

ltem Characteristics
Reference standard GB10188(IEC 60384-13)
Climatic Category 40/85/21
Rated Voltage 630V
Capacitance 0.022μF
Capacitance Tolerance ±5%(J)
Voltage proof 1.6UR(2S)
Dissipation Factor ≤0.002(20℃,1KHz)
Insulation Resistance



Size of CBB21 223J 630V Film Capacitor


CBB21 223J 630V Film Capacitor

W: 13.0mm
H: 10.0mm
T: 5.0mm




Q:Film capacitors have been wave soldered, lead-free soldered, about 200 degrees? High temperature can easily damage the capacitor or affect the life. Don’t know how this industry is controlled and handled? Is manual welding required? Is there a temperature limit in the capacitor specifications? Is the solder joint temperature or body temperature when labeling?

A:Hello, the temperature of the wave soldering peak of the film capacitor can be 275 ° C, which is also the temperature of the IEC standard, and the tin immersion time is 3S-5S. The other is the preheating temperature and time. Film capacitors can withstand this temperature. Does not affect electrical characteristics. The solderability temperature and soldering heat resistance temperature are stated in the specification approval book. The former is aimed at the solderability of capacitor pins, while the latter is about the influence of welding temperature on the characteristics of film capacitors.

Q: How to judge the quality of the film capacitor?

A: 1) Use a multimeter to test the resistance of the thin-film electricity. The two feet should be very high resistance. If there is a capacitance meter, measure whether the capacitance value matches the mark on the case.

2) Test performance at room temperature, including capacity, loss, insulation resistance, withstand voltage, ESR, etc.

3) Do simulated life test.

Contact Us


Ph/(whatsapp): +86-18825879082

Skype: Coco.PSH



Go to Top